FRAME RELAY SETUP

FRAME RELAY SETUP:
 

Config# interface serial 0

Config-if# encapsulation frame-relay - cisco by default, can change to ietf

Config-if# frame-relay lmi-type cisco - cisco by default, also ansi, q933a

Config-if# bandwidth 56

 

Config-if# interface serial 0.100 point-to-point - subinterface

Config-if# ip address 122.1.1.1 255.255.255.0

Config-if# frame-relay interface-dlci 100
    -maps the dlci to the interface
    -can add BROADCAST and/or IETF at the end

 

Config-if# interface serial 1.100 multipoint

Config-if# no inverse-arp - turns IARP off; good to do

Config-if# frame-relay map ip 122.1.1.2 48 ietf broadcast
    -maps an IP to a dlci (48 in this case)
    -required if IARP is turned off
    -ietf and broadcast are optional

Config-if# frame-relay map ip 122.1.1.3 54 broadcast